#Used mac g5 sale how to
#Used mac g5 sale install

Locate the small, gray inverter cable cover in the top right corner. The black cable (from the previous step) connects to the pins shown below. This picture shows a close up of the connector from step 10. Gently pull the black cable (circled) that is connected under (see next photo) the gray fan duct. Disconnect the two inverter cables by pulling on the connectors, not on the cables. Important: Carefully slide out the inverter so that it doesn't make contact with the DIMM connector latches. Locate the colored cables connected on the right side of the inverter. Remove the three inverter screws (circled below). Locate the gray plastic module on the right side of the computer. Repeat this step if you have a second memory module. To release the memory from its slot, push down on the two side latches (circled below). Rotate the computer to the left so the memory is in the position shown below. You must remove the memory to gain access to the inverter.

Locate the memory module(s) in the bottom right corner.

#Used mac g5 sale install

Warning: Always discharge static electricity before you touch any parts or install any components inside the computerģ. Touch the metal surface (as shown below) on the inside of the computer to discharge any static electricity. As you remove each module, set it aside, along with the screws for that module.

#Used mac g5 sale how to

This procedure will show you how to remove and replace each module. To access the inverter other service modules have to be removed. Holding the back cover by the metal foot, tilt the cover up and lift it off th Don’t force the screws once they stop turning. Turn the screws to the left until they stop turning. Using the tool provided, or a Phillips #2 screwdriver, loosen the three captive screws. Note: These screws are captive they are part of the display/bezel assembly and cannot be removed.

You may have to lift the stand to locate the middle case screw. Locate the three silver case screws circled below. Hold the sides of the computer and slowly lay the computer face dĤ. Place a soft, clean towel or cloth on the desk or surface. Disconnect all cables, and unplug the power cord from your computer. Turn off your computer by choosing Shut Down from the Apple (K) menu. The models may look slightly different from one shown in the illustration however, the following procedure applies to both models. Opening the Computer Note: These instructions cover the iMac G5 (20-inch) models. The procedure will show you how to ground yourself. Ground yourself when working on the computer. Remove the gray plastic inverter cover before returning the inverter to Apple. A magnetized “L”-shaped Phillips screwdriver is included with the replacement part. Do not remove screws unless they are brass colored, or you will void your warranty. All customer removable screws are brass colored. Flat-blade screwdriver Part Location Important: Removing the inverter must be done carefully to avoid fracturin.Screw tray or equivalent to hold the screws.Use the screwdriver provided, or a Phillips #2 screwdriver, preferably with a magnetized tip.Failure to follow these instructions could damage your equipment and void its warranty.  iMac G5 Inverter, 20-inch Replacement Instructions Follow the instructions in this document carefully.